Cassiope Modular Bike Phone & Action Camera Handlebar Mount

About this item

Hassle-Free Exchanges & Returns for 30 Days. · 6-Month Limited Warranty. One Mount, Two Ways to Ride Switch between smartphone navigation and action-camera recording without replacing the main handlebar clamp. The modular connector system allows you to configure the mount for different riding needs. Use the phone holder when following a route, or attach a compatible action camera when you want to record the ride. Important: The phone and action camera are used separately. The mount supports one device at a time. Modular Mounting Configuration The kit includes long and short connector pieces that allow the device position and orientation to be adjusted according to the selected setup. Use the different components to: Configure the mount for a phone or action camera Position the device horizontally or vertically where compatible Adjust the device closer to or further from the handlebar Change the setup without removing the main clamp The modular design provides more configuration options while keeping the bicycle cockpit organised. Flexible Angle Adjustment The adjustable connector joints help fine-tune the viewing or recording position. Loosen the appropriate thumb screw, move the connector to the preferred angle and tighten it securely before riding. Suitable for: Phone navigation Route and fitness-app viewing Forward-facing ride recording Different bicycle geometries and riding positions The available adjustment range depends on the selected connector configuration and attached device. Secure Anti-Slip Clamp The handlebar clamp features textured anti-slip contact pads that help increase friction against compatible round bars. The screw-locking mechanism helps: Reduce unwanted movement during normal riding Maintain a more consistent device position Protect the handlebar contact area Provide tool-free installation and removal Designed for round handlebars or tubes measuring approximately 20-30mm in diameter . Lightweight, Compact Design The mount weighs approximately 88g before optional accessories are fitted. Its compact ABS and stainless-steel construction adds mounting flexibility without placing unnecessary bulk on the handlebar. Suitable for: Road cycling Mountain biking Recreational riding E-bike use Commuting Outdoor recording Installation Loosen the lower locking screw. Open the clamp. Position the clamp around a compatible 20-30mm round handlebar or tube. Tighten the lower screw until the clamp is secure. Install the required connector and either the phone holder or action-camera interface. Adjust the device position and tighten all thumb screws before riding. Inspect every connection before use and check the mount again after riding on uneven surfaces. What's in the Box Based on the selected expanded configuration: 1 × Main handlebar clamp 1 × Long connector 1 × Short connector 3 × Thumb screws 1 × Phone holder 1 × 1/4-inch adapter Smartphone, action camera and bicycle are not included. Compatibility and Safety Notice Measure the mounting bar before purchasing; it must fall within the 20-30mm diameter range. The action-camera connection is intended for compatible three-prong mounting interfaces. Smartphone compatibility depends on the phone dimensions, case thickness and phone-holder opening range. Use either the phone holder or action-camera attachment-not both simultaneously. Do not use the device while actively operating the bicycle. Tighten all screws before every ride. Stop using the mount if any component becomes cracked, loose or damaged. What's in the box 1 x Main handlebar clamp 1 x Long connector 1 x Short connector 3 x Thumb screws 1 x Phone holder 1 x 1/4-inch adapter